Not sure how to finish the layout and even if the layout is optimal
2 Comments
Jean-Francois
June 11, 2009
Looks good to me!
…
Ok I absolutely have no idea what this all mean..
Have you thought about writing tutorials or learning-oriented posts? I think it would be more appealing than small blurbs of random thoughts or statements.
Always try to use gnd plane in audio projects. But in think it is more important in pre-amplifiers. Also gnd must be connected at one point. This is hard to achieve. I try to make one side board and use whole 2 side as ground plane. I use big drill bit to remove copper from around component’s pins on gnd side.
I just started to work on same chip based amplifier, and was wondering if you could send me eagle lbr for LME498xx? or STD03N/3P pair? Or both Regards from Slovenia!
2 Comments
Jean-Francois
June 11, 2009Looks good to me!
…
Ok I absolutely have no idea what this all mean..
Have you thought about writing tutorials or learning-oriented posts? I think it would be more appealing than small blurbs of random thoughts or statements.
Primoz
December 9, 2009Always try to use gnd plane in audio projects. But in think it is more important in pre-amplifiers. Also gnd must be connected at one point. This is hard to achieve. I try to make one side board and use whole 2 side as ground plane. I use big drill bit to remove copper from around component’s pins on gnd side.
I just started to work on same chip based amplifier, and was wondering if you could send me eagle lbr for LME498xx? or STD03N/3P pair? Or both
Regards from Slovenia!